SUREFIRE MR14A SIG P226 ADAPTER RAIL Light Interface rail

SUREFIRE MR14A SIG P226 ADAPTER RAIL Light Interface rail


DETERMINING WHICH VERSION FITS YOUR P226
Serial numbers of 300,000 or lower — MR14A
Serial numbers above 300,000 — MR14B (NOT AVAILABLE)
-or-
Measure the trigger guard's width:
If trigger guard is 10 mm wide — MR14A
If trigger guard is 11.5 mm wide — MR14B (NOT AVAILABLE)


The MR14A attaches to rail-less SIG P226 pistols, providing the required accessory rail to mount the X Series WeaponLights. With the MR14 attached, the X Series WeaponLights can be easily slid off your pistol, carried separately, and slid back on when needed. SureFire made an A and B version to accommodate two variations in the P226 pistol design (see below).
THIS PRODUCT IS NO LONGER MADE BY SUREFIRE, LIMITED TO STOCK ONHAND.

X200, X300, X300U, X400, X400U, XH35, X300UH, X400UH etc.

The MR14 fits snugly and securely to the pistol. Made from high-strength 7075 aluminum and stainless steel, the MR14 provides outstanding durability. Its design allows tightening or removal with a cartridge rim — no hex wrench is necessary. An elastometer pad with a reinforced steel edge keeps the mount snug against the trigger guard without scratching, and an integral anti-chafing pad prevents scoring or scratching of your pistol's dustcover or frame. This lightweight, low-profile mount is slim enough to allow the pistol plus mount to fit most holsters made for the P226.

DETERMINING WHICH VERSION FITS YOUR P226
Serial numbers of 300,000 or lower — MR14A
Serial numbers above 300,000 — MR14B (NOT AVAILABLE)
-or-
Measure the trigger guard's width:
If trigger guard is 10 mm wide — MR14A
If trigger guard is 11.5 mm wide — MR14B (NOT AVAILABLE)



* Slim design allows holstering pistol plus mount in most pistol-appropriate holsters
* Anti-chafing pad prevents frame damage
* Construction: ultra high-strength 7000-series aluminum
* Weight: 1.10 ounces